Contributing

How do you check hydraulic fluid on a Massey 135?

How do you check hydraulic fluid on a Massey 135?

As you sit on the tractor, the dipstick SHOULD be right behind your right foot, on the side of the tranny housing/rear end housing. It SHOULD be in the same round bolt-on part where the hydraulic flow control is located. No, it ISN’T a screw-in dipstick.

How do you troubleshoot a hydraulic pump?

HYDRAULIC PUMP NO-PRESSURE CHECK LIST

  1. CHECK YOUR DIRECTIONAL CONTROL SETTING.
  2. CHECK THAT YOUR PUMP IS RECEIVING FLUID.
  3. CHECK THAT YOUR DRIVE MOTOR IS NOT REVERSED.
  4. CHECK THAT YOUR DRIVE MOTOR IS OPERATING CORRECTLY.
  5. CHECK TO SEE IF YOUR PUMP COUPLING IS DAMAGED.
  6. CHECK YOUR PUMP RELIEF VALVE.
  7. CHECK FOR MECHANICAL DAMAGE.

Does hydraulic Stop Leak work?

BlueDevil Hydraulic Stop Leak will mix with the hydraulic fluid in your system and can stay there permanently, or even be retreated. BlueDevil Hydraulic Stop Leak works so well it is guaranteed to make a permanent seal.

Are there hydraulic problems with a Massey Ferguson MF 135?

MF 135 (early UK model). That high pressure stand pipe HAS to be back in the the CORRECT SPOT. It’s not easy to do and it cannot be damaged one bit. They are not very expensive if you have to replace it. With that big control block it’s tougher to do……

How big of a load can a Massey Ferguson pick up?

I have a Massey-Ferguson 135 and the lift will not pick up a heavy load (approximately 350-400 lbs.). Also I not when I have a Massey-Ferguson 135 and the lift will not pick up…

What kind of lift does a Massey Ferguson have?

I have a older 135 massey ferguson without a two stage clutch. I have a older 135 massey ferguson without a two stage clutch. The lift works fine up to about 300 lbs. However, when the lift guits lifting because … read more

What are the hydraulics on a Massey Ferguson tractor?

The control quadrant levers seemed already frozen and could never be moved, but this in no way affected the main draw bar hydraulics, until I lifted and replaced the unit. The unit has an oil gallery (Supply?) and floating vertical pipe (return) interface with the main housing.