What does Fl mean on my Samsung washer?
What does Fl mean on my Samsung washer?
FL. The washer failed to lock the door.
How do I fix FL error on my Samsung washer?
If the door fails to unlock after seven tries once the washer cycle is complete, you’ll get the LO or FL code. Begin by unplugging the washer, and force open the door. Check the wiring connections to the door lock/switch, and tighten if needed.
What does Fl mean on my washer?
The Whirlpool washer Lo FL error code is displayed when water is not detected entering the washer or it’s not filling the washer fast enough. Make sure the water supply hoses are not kinked or pinched and that screens in the supply line are clear of debris.
How do I fix the code on my Samsung washing machine?
Occasionally, the UR error code is caused by a fault with the electronic controller, which has mistakenly identified an unbalanced load error when there is none. Resetting the washer by disconnecting the power to the washer for 10 minutes should fix the issue.
What does F mean on washing machine?
The F indicates that the washer control detected a component problem. If the F code was caused by excessive suds preventing the washer from draining, you may be able to shut the door and run a drain/spin cycle to remove the water from the washer.
What does code DC mean on Samsung washer?
unbalanced
A dc error code on your Samsung front-load washer means the washer won’t spin because the load is unbalanced. Fixing a dc error code can be as easy as redistributing an unbalanced load or adding a few garments to a small or single-item load.
What does Fl mean on my air conditioner?
The P2 or FL error code (depending on model) indicates that the drain pan in the unit is full. Under normal operating conditions, the drain pan will not need to be emptied. The unit is designed with a slinger fan that is mounted above the drain pan.
How do I unlock my Samsung superspeed steam VRT?
The washing machine door will be locked when it detects water in the unit. Wait and see if it drains out by itself. When water is no longer in the washer, reset the washer by pressing the ON/OFF or START/PAUSE button. Then wait for a minute to pass, and you can then unlock the door.
What does it mean when my Maytag washer says FL Lo?
The F8 E1 or Lo FL error code means your washer is not detecting the correct amount of incoming water. Press the power button, and the washer will start a drain routine, which takes approximately 8 to 10 minutes, during which time the pump will run continuously. The control will not accept any input during this time.
Why does my washer keep saying LF?
Whirlpool Washer LF Error is a water fill error, it stands for Long Fill. It means that the main control has not gotten a signal back from the water pressure sensor which means that water is not filling the tub or not filling the tub fast enough.
How do you fix an unbalanced washing machine?
If something has shifted, you can relevel a top-loading washer by tipping the washer forward, then placing it back on the floor. Front-loading washers level by turning a leg to raise or lower it. You may need to open the front access panel to loosen the lock nuts that control the legs.