How do I fix the F01 fault on my Hotpoint washing machine?
How do I fix the F01 fault on my Hotpoint washing machine?
When your washer dryer shows error message F01, we advise you to disconnect and unplug your Hotpoint washer dryer from the mains supply for 3 minutes. After 3 minutes have passed, reconnect your Hotpoint washer dryer and wait 30 seconds before you start up the machine again.
Why does my Hotpoint washer say F 05?
F05 means there is a problem with the pump or there is a waste pipe issue. This problem will mean that your washing machine door may not release, leaving your washing trapped inside, or if it is opening, your washing will be sat in a pool of undrained water.
Why are the lights on my Hotpoint washing machine flashing?
End light flashing Indicates that the Hotpoint washing machine has reached the end of a wash programme. If the wash, rinse and spin function lights all flash at the same time, this would indicate a possible blockage in your filter or waste / drain pipe.
How do I fix Hotpoint F06 error?
When your Hotpoint washer dryer shows error message F06, you will need to check the door area for any obstructions. Closely inspect the door lock and surrounding areas, removing anything in its way. Once you have cleared any obstructions, try to restart the machine programme.
What does F 03 mean on a washing machine?
Temperature sensing fault Issue
F02 — Motor circuit fault. Issue: Intermittent or no drum rotation during wash cycle. Advice: We recommend you call our customer service centre to book an engineer on: 0344 822 4224. F03 — Temperature sensing fault. Issue: Washing Machines not heating on wash or dry settings.
How do I reset my Hotpoint washing machine?
Locate the “On/Off” button. You can find the button on the left side of the control panel. Press and hold the “On/Off” button. Release the button after three seconds.
How do I fix F07 error?
The only thing you can do is try and reset the control by unplugging the washer or killing power to it at the breaker for a minute and restore power. If the F07 error persists after that then the motor control unit / MCU will need to be replaced.
How do you reset a Hotpoint washing machine?
What does F06 error mean?
drive motor tachometer error
The “F06” fault code indicates a drive motor tachometer error. This means the control is unable to properly detect motor speed and the machine will shut down. It could also be the tachometer circuit in the motor or an intermittent internal component connection within the (MCU).
What are the error codes on my hot point washing machine?
Below are a list of the most common error codes that will appear on the digital display of your Hotpoint washing machines, along with the fault type and a description of what’s gone wrong: We would recommend you check the hoses and filters for any signs of blockage.
Can a hotpoint error code be changed at any time?
Hotpoint error codes are subject to change at any time, so the advice here might not be relevant to your specific machine. Also remember that, if you decide to inspect or repair your machine yourself, you must always unplug it from the mains and exercise caution.
Is there a recall on Indesit hot point washing machine?
Safety Notice: A recall has been launched relating to the door lock system for certain Hotpoint and Indesit washing machines. Find out more here. Issue: During a wash cycle the programme pauses part way through/ the machine is not heating and the pump runs continuously.
Why is my glotech Hotpoint washing machine not working?
F18 on that model is a PCB Module fault so the PCB will probably need replacing. Unfortunately this is not something that you can do yourself as it will need programming after fitting and engineers need special equipment to do this.