How do I stop spinning shocks?
How do I stop spinning shocks?
Regardless you could use some pliers and wrap the shaft with a small strip of mouse pad – this will protect the shaft from gouges and will allow you to keep the shaft from spinning when you tighten the top nut. ARE YOU KIDDING ME? This is the best way, bar none to ruin your new shocks.
What happens if you over tighten a strut bolt?
Any nut or bolt which is over tightened is essentially over stretching the bolt, or in this case the strut tube. This can lead to premature failure of the strut and require early replacing. Over tightening also compresses the spring down further on the strut, causing preload to the spring.
How tight do you tighten shocks?
you dont need to torque the old post top shock, ones with two rubber washers and the nut. Just tighten the nut down till the rubber washer is just starting to squish, then go about 5 turns more. kinda in the middle of when it starts to squish and before you totally colapse it .
How do I stop my rear shock from spinning?
Step one: Remove the lower bolt that attaches the shock to the axle. From there, let the shock fully extend downward. This will create a cavity/clearance that will allow you to get a small set of vice grips in. This gave enough grip/bite to get the bolt off with minimal spinning of the piston.
How tight should rear shock bolts be?
When installing new shocks, the goal is to tighten them just enough that there is no play or chattering in the suspension over bumps. But not so much that it adds any noticeable resistance to the shock’s pivot points. After adjusting the tension on each bolt, bounce the suspension by hand.
Can you over tighten a strut mount?
Do not use an air or electric impact wrench to tighten the upper mounting nut on the piston rod. This can make the torque higher than recommended and cause damage.
How tight should front shock bolts be?
3. The fasteners should be tightened until the bushing expands (bulges) to the same outside diameter of the metal washer. (see below) This allows for the proper amount of bushing squeeze so that the shock absorber can move properly in any direction.
How do you tighten a spinning nut?
7 Answers. Best way: put a wrench on the nut and the proper driver or socket into or over the head of the bolt, and turn one while keeping the other stationary. Second best way: put a wrench on the nut, and a pair of locking pliers on the shank of the bolt.
How can I get a bolt that is spinning out of place?
From basic toolbox items to the tools of serious handymen, there are a number of methods you can try to remove a bolt that keeps spinning in place. Aim to get the nut out of place, especially if the bolt and nut are spinning together. Once you can pry the nut out of place, the bolt will come loose too.
What happens if you tighten a bolt and it spins?
So you don’t have an issue “currently” with a spinning bolt. However, your bolt isn’t spinning because you have managed to over tighten it. This too can be harmful to whatever project you are doing. When you over tighten or over-torque a bolt you could strip the bolt or even snap the screw heads.
What to do if a screw keeps spinning?
Aim to get the nut out of place, especially if the bolt and nut are spinning together. Once you can pry the nut out of place, the bolt will come loose too. If you have a magnet handy in your toolbox, you can use it to attract the spinning screw to force it out of place.
Why does my car bolt keep spinning in place?
The bolt may spin in place due to a few different reasons: A hole with specks of dust can prevent the bolt from staying in place. It acts as a lubricant. Another reason may be that you have the wrong-sized bolt.