Q&A

Do P traps need washers?

Do P traps need washers?

You need a washer where the tail piece goes into the trap. No washer where the trap connects to the wall pipe. It’s a 1 1/2″ trap.

Where is the P-trap location for washing machine?

F. is the p-trap, a washing machine pipes p-trap must be installed above the floor, at least 6″ above but not more than 18″ above.

Can washer and sink share P-trap?

You can eliminate the washing machine standpipe and elbow out to a sink drain & P-Trap and then drain the washing machine into the sink. You cannot have the washer and the sink share a trap!

Where should P-trap be?

The P-trap should be located no more than 24” below the drain. There is no minimum distance for how far below the drain a P-trap should be.

Can a washer and kitchen sink share a drain?

If you’re joining a washing machine and kitchen sink on the same drain, you may be able to vent them both with a single vent if they are close enough together. If not, you can connect their separate vents before they tie into the main vent stack.

Can you hook up a washer to the sink?

If you do not have designated plumbing for your washing machine, you can hook it up to a sink instead. Use a sink aerator thread to hose connection adapter to attach the water supply hose to the sink faucet. Connect the other end of the water supply hose to the cold-water connection on the back of the washing machine.

What is the standard height for a p-trap?

2 Answers. The trap is usually attached to the end of the tailpiece, and tailpieces are typically between 6 – 8 inches long (though I’ve seen up to 12). So the “standard” height of a trap would be, 6 – 8″ below the fixture.

Does trap have to be directly below drain?

The “P” trap SHOULD be directly under the drain, but no more than a few inches off center of it, if conditions require it. NO trap, TWO traps, and/or a 9 foot offset are NOT allowed and if he suggests any of them get a different installer who is a REAL plumber.

Where do you put the P trap washer?

Please try again later. P-trap washers sit on the ends of the P-trap underneath the sink. Replace the P-trap washers with the help of this free video presented by a professional and experienced plumber. Bio: Terry Matsamas has worked for Towers Murray Plumbing since 1991.

Can a slip joint washer be used with a P trap?

Slip joint washers are also known as P-trap washers because slip joints are often used with P-traps. Both plastic and rubber P-trap washers can be used with different pipe material, such as PVC and brass. Access the area under the sink where you will be installing the slip joint.

Do you need a trap to drain a washing machine?

Washers, like all fixtures, need a trap. The correct way to drain a washing machine is to install a standpipe. That is a vertical length of pipe that connects to a P-trap that, in turn, connects to the drain.

Can A P trap and drain save you money?

Washing Machine P Trap And Drain – Plumbing – DIY Home Improvement. washing machine diagram Laundry Room Design, Laundry In Bathroom, Laundry. A bit of knowledge about plumbing can save you lots of money. You might have given it some thought before, but never made any time to gather information.