How do I configure a port on a Cisco switch?
How do I configure a port on a Cisco switch?
Steps
- View the port groups available in a Cisco switch: show port-resources module blade_number.
- License and acquire the required port in a port group by entering the following commands in sequence: config t interface port_number shut port-license acquire no shut.
- Save the configuration: copy running-config startup-config.
How do I set up a Layer 2 switch?
You can configure Layer 2 switching ports as access or trunk ports….You can configure a static MAC address for the following Layer 3 interfaces:
- Layer 3 interfaces.
- Layer 3 subinterfaces.
- Layer 3 port channels.
- VLAN network interface.
What is port configuration?
The Port Configuration window displays the port configuration and provides access to a window for modifying port configuration. Port configuration values are: Port. Slot and port number for each port installed in the switch (for example, A1 means the first port in slot A).
Why would you configure an IP address on a switch?
If you want to be able to manage your switch remotely over the network, your switch needs an IP address. If your switch has multiple VLANs configured, and you want to be able to manage the switch from each VLAN, the switch requires an IP address on a VLAN interface in each VLAN.
How to configure a routed port-switched network?
Step 1 : Configure IP routing. Step 2 : Create a routed port. Step 3 : Assign an IP address to the routed port. Step 4 : Configure the IP routing protocol if needed. To configure a routed port, perform these steps. 1. Enable IP routing on the router. 2. Create the SVI interface or navigate to configuration mode for the interface. 3.
How to configure two switches and a router?
I assume the trunk (fa0/1) switch interfaces are connected to the router – if that’s the case, you’ve got an “access vs. trunk” mismatch between the switches and the router: either change fa0/1s to access mode, or define sub-interfaces gi0/0.10 and gi0/1.20 on the router and move its .1 IPs there. 08-02-2016 04:38 AM 08-02-2016 04:38 AM
How to connect 2901 router to 2 switches?
I have connected 2901 router to 2 switches (2960). Vlan 10 is configured in switch 1 and Vlan 20 is configured in switch 2. Ip address of host in switch 1 is 192.168.1.10 and ip address of host in switch 2 is 192.168.2.10. I need to communicate between the 2 hosts. But Its not communicating.
How to connect two LANs to a router?
1: Connect through Ethernet ports: use a crossover cable to directly connect the routers together through two Ethernet ports. 2: Connect through serial ports: use a DCE/DTE cable to connect the serial ports. 3: Connect through auxiliary user interface (AUI) ports: connect two routers through AUX (AUI speed up to 115.2 k bps).