How do I know which Lowrance transducer I have?
How do I know which Lowrance transducer I have?
Sometimes an angler needs to identify what model or type of transducer is plugged into their unit. Simply look at the transducer cable, about an inch from the connector. A silver tag is attached to the cable with the transducer model printed on it. For example, see the HST-WSBL transducer in the first image below.
Does TotalScan transducer work with HDS 2?
TotalScan is not compatible with HDS Gen 2.
How do I identify my transducer?
Simply look at the transducer cable, about an inch from the connector. A silver tag is attached to the cable with the transducer model printed on it.
Does Lowrance HDI transducer have CHIRP?
You are correct, the HDI transducer is not a true chirp transducer. I have one on my trolling motor connected to my bow unit. The medium chirp setting is a much clearer image than the 83 or 200 kHz frequencies.
What is the best transducer for Lowrance HDS Gen 2?
The transducer for the LMS-525 is a dual frequency of 50/200 kHz. This would work with either of your new units but ideally you want the PDRT-WBL 83/200 kHz for shooting through the hull.
What is the difference between chirp and sonar?
CHIRP fishfinders transmit a longer pulse than traditional sonar, putting more energy into the water column, with a true broadband frequency range of up to 117kHz. A traditional sonar transmits about one percent of the time, but CHIRP sonars transmit ascending pulses that are ten times as long in duration.
What kind of transducer is the Lowrance lss-2 StructureScan?
LSS-2 StructureScan HD Transducer Name Value Connection Interface Ethernet Frequency 455/800 kHz Maximum Depth 600′ Specific Transducer Skimmer Transducer
Which is transom mount for lss-2 StructureScan HD?
Only 4 in stock! Enhanced imaging transducer generates three dedicated signals for photo-like images to the left, right and directly beneath your boat. Nylon Transom-mount Transducer for LSS-2 StructureScan HD is a low profile, low-drag design with built-in water temp sensor, made for multiple mounting locations—transom, transom step or jackplate.
Can a skimmer be mounted on a lss-2?
A couple people mounted the lss-2 right next to their skimmer transducer and what looks to me like in a place where the motor would interfere. Other people went so far as to take a level out on the boat and then jacked the trailer up in the garage to the same level before mounting.
Can a lss-2 be installed on a hds-5?
I added on a Sonarhub and LSS-2 tranducer to my HDS-5 with 83/200 tranducer. I installed the LSS-2 about 6 inches away from the 83/200 and the top of it is about even with the bottom of the 83/200 if you look from the side.