How do I restart my pilot light on my furnace?
How do I restart my pilot light on my furnace?
How to Relight a Pilot Light: 5 Steps
- Find the pilot light assembly and its reset switch. The furnace’s pilot light is usually positioned at the bottom of the unit by a knob.
- Set the reset switch to off. Turn the knob to the “Off” setting.
- Wait a moment.
- Relight the pilot light.
- Observe the furnace.
Where is the reset button on my Lennox furnace?
Examine your furnace and look for a raised button or switch to the right of the ignition control box (or the “Limit Control” switch). Press and release the limit control switch to rest your Lennox furnace.
How to re-light the pilot flame on a Lennox Furnace?
Light a match and hold it close to the opening of the pilot flame jet, which is located inside the furnace. This should re-light the pilot flame. Turn back on the power, then the main gas supply. Raise your thermostat to the desired temperature. Your furnace should ignite.
How do you turn on the pilot light on a gas furnace?
Turn the gas control knob or knobs to the ON position. Replace the access panel. Turn the electrical power to the furnace back on. Set your thermostat to your desired temperature. After a few seconds, the pilot will light up, igniting the furnace’s burners.
How to troubleshoot a Lennox home heating system?
Start by finding your electrical panel and switch off the circuit breaker (labeled “Furnace” or “Heating System” to avoid any risk of electrical injuries. Then locate your furnace control panel, lift it up and away from the appliance and set this aside for now.
What do the error codes on a Lennox Furnace mean?
Lennox furnaces have different error codes, each with a meaning. The common ones; It means your furnace ignitor can’t activate the flame. Check for gas flow, igniting lighting burner, flame sensor current. High pressure switch is not closing.