How do you program a catx4 remote?
How do you program a catx4 remote?
Programming Procedure:
- Turn the ignition ON.
- Press and hold the valed/override button.
- Within 10 seconds the system will chirp/flash the parking lights (3) three times, release the button.
- Press Button 1 of each transmitter you wish to program.
- Turn the Ignition OFF to exit programming.
How Do You Use Code Alarm Remote Start?
DO NOT remote start the vehicle if it is garaged. To begin the 2 / 3 hour start up timer mode: Turn the vehicle’s ignition ON then OFF. Press and hold the valet button….Operating on the Code Alarm CA4053 Remote Start System.
| Function: | Beeps / LED Flashes: |
|---|---|
| Confirm Remote Start | 4 Beeps / Flashes (repeats 3 times) |
Where is valet button?
Typical locations for valet switch: Under the driver’s side dash (mounted in the under-dash covering trim panel or wire-tied to a harness) Mounted in the driver’s side kick panel. Mounted in the steering column plastic housing.
How do you get code alarm out of valet mode?
Turn the ignition key to the ON position. Within 10 seconds, press and release the valet push button switch. The alarm system will stop sounding and enter the (by-passed) mode.
What is valet button on remote starter?
Valet mode is a setting/feature your remote starter has, that allows you to disable the ability to remote start the vehicle. It is designed to be used when you take your vehicle in for service or if you are lending the vehicle out and wish to prohibit (ie turn off) the ability to remote start the vehicle.
What is the valet override button?
The valet button or switch permits the owner to temporarily bypass the alarm functionality of the system. To enter or exit valet mode, disarm the system with a working transmitter, your personalized manual override code, or using the procedure below which is to enter or exit valet mode. 1.
Where is the valet override?
The first method is to locate the “valet switch”, which is a small, black, momentary switch usually located towards the bottom of the dash on the driver’s side of the vehicle.
How do you bypass an alarm code?
Bypass a Zone
- Enter the following: Your 4-digit code. The number 6 (bypass button) Two-digit zone number of the zone you want to bypass. (01, 02, 03, etc.)
- Repeat this process for all zones you would like to bypass.
- Once your system is disarmed, this process will need to be repeated in order to arm your system again.
How do I get my car remote starter out of valet mode?
To get the system out of valet mode, try pressing the lock and trunk buttons at the same time for 1/2 a second. Problem solved! Many remote starter systems will use a switch to put the system in valet mode.
What causes remote start to stop working?
The single biggest thing that can cause a remote starter not to engage is a faulty or missing hood switch. This device gets installed under the hood of your vehicle and prevents the engine from starting when the hood is up.