How do you remove the Staywell cat flap?
How do you remove the Staywell cat flap?
- Unscrew the two screws on the outside of the unit.
- Take off the inside section and unscrew the two smaller screws above the door flap.
- Unclip the inside cover. The clips are on the underside of the unit.
- Unclip the plastic clips on the underside of the unit.
- You can then see inside the unit and put in the springs.
How does petsafe cat flap work?
Using radio frequency identification (RFID) technology, it works by reading your cat’s unique microchip ID without the need for a collar or accessory. When your cat approaches the cat flap, the flap will respond by allowing only your cat to enter.
How do I reset my petsafe cat flap?
To power down and then reset the door:
- Unplug the power.
- Take out the battery.
- Press and hold the red button for 10-15 seconds. This will clear the circuit board.
- Plug the unit back in.
- Press and hold the green button for 30 seconds to restore the door to default settings.
- Put the battery back in.
How do you stop a cat flap?
I would stick a large bit of card/plywood painted the same colour as the door over the flap so it isn’t visible to the cat. I would then ensure a secure block was on the other side, a bit of mdf etc attached with silicone sealent will do the job, if you don’t mind marks on the door you could also hadd screws.
How does an electronic cat flap work?
They work by sensing the unique identifying microchip of your cat. This prevents other cats and animals from entering the house through the same flap and reduces the risk of intrusion through the entrance on the door, while allowing your cat to come and go out of the house as they please.
How do you lock a StayWell cat flap?
Unscrew the two screws on the outside of the unit. Take off the inside section and unscrew the two smaller screws above the door flap. Unclip the inside cover. The clips are on the underside of the unit. Unclip the plastic clips on the underside of the unit. You can then see inside the unit and put in the springs.
Why is my StayWell deluxe infra red cat flap not working?
The door will not recognise the collar key for the 500 Series Deluxe Infra-Red Cat Flap. You’ll need to power down and reset the circuit board. Take the batteries out for at least 30 minutes. This will clear the circuit board memory. Put the batteries back in. The red LED light should flash.
How do you put batteries in a cat flap?
Install 4 AA batteries into the cat flap. Install batteries in the key. To the left of the circuit board on the flap, there are two buttons, ‘Manual’ and a ‘Learn’ button. Press the ‘Learn’ button and hold the key up to the door. The LED light on the cat flap should start to flash green. The key is now programmed.
Where can I buy a new cat flap?
Replacement flaps can be purchased through our Customer Care Centre. To ensure we send you the proper flap we will need to ask some questions about your door. Please be near the door so that you can respond to these questions and call our Customer Care Centre. I have an older model pet door and want to replace it with a different pet door.
https://www.youtube.com/watch?v=Nd9Ib0iF4oM