How do you use autopage remote?
How do you use autopage remote?
KE-155R
- Enter your vehicle and close the doors and trunk behind you.
- Insert the key into the ignition and switch it from “Off” to “On” three times, ending in the “On” position after the third cycle.
- Push the valet switch on your Autopage alarm twice.
- Press any button on your keyless remote starter.
What is the valet switch on autopage?
The valet button or switch permits the owner to temporarily bypass the alarm functionality of the system. To enter or exit valet mode, disarm the system with a working transmitter, your personalized manual override code, or using the procedure below which is to enter or exit valet mode. 1.
How do I turn off valet mode on autopage?
Exit Valet Mode: Push and hold valet switch for 2 seconds; the LED will turn off indicating the system is exiting the valet mode.
Who makes autopage remote start?
Auto Page was sold to automotive lighting company Varad in 2012. As of last year, Auto Page had about 100 dealers while in its heyday it worked with 300 to 400 dealers, said one industry member. Auto Page was a well-regarded remote start brand for many years.
Why is my automatic car starter not working?
Cause: It is rare, but does happen – in most cases, this is caused by a dead battery in the vehicle or the battery having been disconnected when being serviced. Remote starters usually have some type of non-volatile memory to retain things like programming features and remote control codes.
What is the point of valet mode?
The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to hand your transmitter to parking attendants or garage mechanics. When the system is in valet mode, all alarm functions are bypassed, however the remote panic feature and remote door locks will remain operational.
How do I know if my car is in valet mode?
Cycle the vehicle key in the ignition between the ‘On’ and ‘Off’ positions 5 times. Do not touch anything on the remote. You will know that you have entered valet mode if you see the parking lights flash one time and/or you hear a faint click from within the dash.
How does a valet switch work?
The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to hand your transmitter to parking attendants or garage mechanics. Press and hold the valet pushbutton switch or turn the valet switch to the off position. The system will remain in the valet mode.
What happened to autopage?
How does a car alarm system work?
If your car’s angle changes, the tilt sensor sends a signal to the computer, which activates the alarm. Modern tilt sensors use mercury, which conducts electricity, to monitor a car’s tilt level. If the car’s angle suddenly changes, the mercury flows to one side and causes the switch to activate, sounding the alarm.