Should I use Loctite when mounting a rifle scope?
Should I use Loctite when mounting a rifle scope?
The quick answer is no we don’t, not unless something indicates to us that it is needed. Most of the companies that make rings and mounts recommend not using Loctite for a couple of reasons. Instead of using Loctite we prefer to use a torque wrench that measures in pounds per inch.
How tight should scope screws be?
A good rule of thumb is to have the rings as far apart as possible for your particular scope. Once the rings are in the correct location, remove scope, push forward and tighten each ring (the 1/2″ nut) finger tight, using your 65 INCH-POUND torque wrench tighten each nut.
Which way do scope rings go?
Install the optic in the rings at the highest magnification, but don’t completely secure the ring screws quite yet. We recommend spacing the rings no closer than 3/8” from the magnification adjustment ring in the rear, and centered, or slightly forward of center on the tube in the front.
Does vortex recommend Loctite?
For example, we do not recommend the use of Loctite or other similar products in mounting our optics.
How far forward should I mount my scope?
Three to 4 inches is about right. You must focus the eyepiece (ocular lens), and thus the reticle, on every new scope.
How many inch lbs Do you need to tighten a scope ring?
when mounting optics with an integrated rail (SR rail, ZM/VM rail), the recommended torque value of screw tightening is 40 in/lbs or 4.52 Nm.
What happens if your rifle scope is not working?
If your rifle scope is not working properly, then your aiming is significantly affected. There are other common rifle scope problems that can affect your accuracy. I will take you through 10 problems shooters experience when using their riflescope. This will help you know how to overcome these problems and hit your targets accurately.
What are the common problems with scope mounting?
Canted or improperly focused reticles and the wrong eye relief were other common problems, but they are topics for future columns. Too-tight screws and out-of-whack rings and bases are two problems that, left uncorrected, could cause you grief, possibly ruin a good scope, and maybe even ruin a great hunt.
What are the most common problems with riflescopes?
1. Scope shift This is one of the most problems that many people experience when using rifle scopes. Scope shift which is also known as the point of impact takes place when you are aiming or sighting the point where the bullet will hit. If you notice that there is a variation, then scope shift has taken place.
How to properly mount a scope presented by Larry?
This feature is not available right now. Please try again later. Properly mounting a scope is a crucial piece of getting the best accuracy from a rifle. Watch as Larry Potterfield, Founder and CEO of MidwayUSA, shows how he installs a rifle scope on a pre-64 Winchester Model 70. Loading…