What is an offset flange?
What is an offset flange?
Unlike a standard flange, which is centered on the waste pipe, an offset flange is off-center—that lets you shift the location of the toilet by a couple of inches (left, right, forward or back).
Can you move a toilet a few inches?
Yes, you can actually move a toilet. Even moving a toilet by a few inches without having to make a new hole in the floor is possible. You can use an offset toilet flange to move the toilet by a couple of inches on any side. This will allow you to use the same wastewater line and in turn help to save you a lot of money.
How far does the toilet flange need to be from the wall?
12 inches
The Distance To Set The Toilet Flange From The Back Wall. You’ll want to set the center of the water closet flange 12 inches from the finished back wall. Don’t measure from the base molding! Take this measurement from the finished wall.
What can a NIBCO closet flange be used for?
The NIBCO 3 in. x 4 in. PVC DWV Offset Closet Flange Hub is used for non pressurized sanitary systems. The sanitary drainage and vent piping are installed to remove waste water and water borne wastes from the plumbing fixtures and appliances as well as provide a circulation of air within the drainage piping.
When to use an open or closed toilet flange?
The open toilet flange requires a test plug or cap for pressure testing and is primarily used in repair work. The closed toilet flange with pre-installed ability for pressure testing is primarily used in new construction. The 45-degree and offset specialty toilet flanges allow for margin of error in drain/pipe alignment.
What is no hub cast iron water closet flange?
No Hub Cast Iron Water Closet Flange Made with a test cap that easily and cleanly breaks out, eliminating the possibility of falling down the DWV line. Ring provides a crack-resistant connection between the water closet outlet and plumbing system that is flush with the floor.