What is condensate drain valve?
What is condensate drain valve?
A condensate drain valve is a type of valve used to drain condensate from process lines or storage tanks. These valves assist in supplying clean and dry compressed air to the system by removing the condensate and contamination from the system.
How does a drain valve work?
Types of Drain Valves Float-operated: This valve allows water to flow into a special housing. When the water inside the tank reaches a predetermined level, a float triggers the drain’s opening and lets the excess water drain out. The drain then opens, but the water flow stops before the release of compressed air.
How does an automatic air drain valve work?
They work by allowing the condensate to gravity feed into the valves condensation reservoir. When the liquid in the reservoir rises to a point where the float lifts off the seats, control air pressure is sent to the pneumatic piston to open the normally closed ¾ ported ball valve.
What is an EcoDrain?
Our EcoDrain is a channel drainage sysetm, also known as linear drainage, and is a popular choice because it is simple to design and install. Using a channel system means that the channel can act as both a multiple point drain and a carrier pipe.
What is condensate trap?
The condensate trap is a device inside a condensing boiler which collects water from the condensing process before it is expelled into the sewer via the condensate pipe. The purpose of the trap is to prevent toxic gases from entering the condensate pipe, and to manage the flow of condensate fluid out of the boiler.
What is compressor condensate?
Compressed air condensate is a by-product of all compressors. It is a mixture of ambient hydrocarbons, compressor lubricant with ambient moisture, and particulates that have been concentrated and removed from the air stream by dryers and filters.
How often should you drain water from air compressor?
It is recommended that you drain your tank daily, whether it is manually or automatically. Water build up in your tank can cause the bottom of your tank to rust forcing you to invest in a new tank. If you find yourself forget about draining your tank, you should look into purchasing an electronic drain valve.
What is a spitter valve?
A water key is a valve or tap used to allow the drainage of accumulated fluid from wind instruments. It is otherwise known as a water valve or spit valve. Baritone saxophones have a water key attached below the top loop of the instrument.
What is drain water heat recovery?
A drain water heat recovery (DWHR) pipe is a simple technology to save on energy used to heat water. The heat from the drain water is transferred through the copper walls of the heat recover unit to warm the cold water before it goes into the water heater.
How do you empty a condensate trap?
Turn off the air conditioner. Remove the condensate drain service cap and slide one end of the coat hanger straight down the the pipe and into the “U” shaped trap. Rotate the hanger a few times to loosen up the nasty stuff in the trap. Remove the hanger from the drain.
How do you unclog a condensate line?
3 steps to unclog your condensate drain line Step 1: Locate your condensate drain line exit Step 2: Connect wet/dry vac to the end of the condensate drain line and make the connection airtight. Step 3: Run wet/dry vac for 5-10 seconds. Repeat until clog is removed. If you don’t have a wet/dry vacuum…
What’s a condensate line, and why is it important?
The condensate line is one of the most important components of your HVAC system.Your condensate line, also known as a “condensate drain line” or “condensate drain” does several jobs, but none are more critical to the functionality of your appliance than draining excess moisture outside of your home.
What does the condensate Pan do?
The condensate pan is a wide and shallow container (about an inch deep) that collects the water condensation. A drain and a pump attached to the pan removes the condensation moisture into the standard wastewater system. Because the pan is shallow, it will overflow should the drain become clogged or the pump stop working.
What is HVAC condensate trap?
Condensate drain traps are the accepted industry standard for evacuating condensate water from the HVAC system without allowing the inflow of ambient air. Proper trap design, system start-up procedures and maintenance (debris removal, water level check, etc.) will result in a functional and worry-free trap.