What is Palo Alto captive portal?
What is Palo Alto captive portal?
The Captive Portal is used to create a user-to-IP mappings on the Palo Alto Networks firewall. The portal is triggered based on the Captive Portal policies for http and/or https traffic only and is triggered only for the IP addresses without existing user-to-IP mapping.
What is Palo Alto policy based forwarding?
Policy-Based Forwarding (PBF) allows you to override the routing table, and specify the outgoing or egress interface based on specific parameters such as source or destination IP address, or type of traffic. …
Is redirecting safe?
However, you need to be sure anywhere you do redirects, they are done safely – otherwise you are putting your users in harm’s way by enabling phishing attacks. If they can “bounce” a user off your website (an apparently valid domain), their messages are less likely to be marked as malicious.
How do I get a PBF in Palo Alto?
Create a Policy-Based Forwarding Rule
- Policies. Policy Based Forwarding. and. Add. a PBF policy rule.
- Give the rule a descriptive name ( General. ).
- Source. and configure the following: Select the. Type. ( Zone.
- Destination/Application/Service. and configure the following: Destination Address. —By default, the rule applies to. Any.
How do you activate the captive portal in Palo Alto?
Configure the Captive Portal settings.
- Device. User Identification.
- Enable Captive Portal. (default is enabled).
- Specify the. Timer.
- Select the. SSL/TLS Service Profile.
- Select the. Mode.
- Redirect mode only. ) Specify the.
- Select the authentication method to use if NTLM fails (or if you don’t use NTLM):
- Click.
How do I activate captive portal?
Configure Captive Portal Settings
- Open Manage.
- Select Configuration > Device Configuration > SSID Profiles.
- Select an existing SSID profile or create a new profile.
- Expand the Captive Portal section.
- Select the Enable Captive Portal check box to display a portal page to be shown to clients on the guest network.
How does PBF works in Palo Alto?
PBF rules allow traffic to take an alternative path from the next hop specified in the route table, and are typically used to specify an egress interface for security or performance reasons.
Does Palo Alto support policy based VPN?
Palo Alto Network firewalls do not support policy-based VPNs. The policy-based VPNs have specific security rules/policies or access-lists (source addresses, destination addresses and ports) configured for permitting the interesting traffic through IPSec tunnels.
Why is redirecting bad?
Well, it depends, but in most cases, no. Redirects are not bad for SEO, but — as with so many things — only if you put them in place correctly. A bad implementation might cause all kinds of trouble, from loss of PageRank to loss of traffic. Redirecting pages is a must if you make any changes to your URLs.
Is Palo Alto route based or policy based?
The firewall can also interoperate with third-party policy-based VPN devices; the Palo Alto Networks firewall supports route-based VPN. The Palo Alto Networks firewall sets up a route-based VPN, where the firewall makes a routing decision based on the destination IP address.
How do you test the captive portal in Palo Alto?
Go to Device > User Identification > Captive Portal Settings. Verify that User ID is enabled on the source zone for the traffic in question. Go to Network > Zones > Zone Name. Verify the host name or IP address specified for the Redirect Host is accessible to the systems expected to use Captive Portal.