What is the difference between a DI box and a Reamp box?
What is the difference between a DI box and a Reamp box?
A DI box converts a high impedance, unbalanced instrument level signal to a low impedance, balanced mic level signal. A reamp box converts a low impedance, balanced line level signal to high impedance, unbalanced instrument level signal. Without the reamp box there will be an impedance mismatch and loss of tone.
Can you use a DI box as a Reamp box?
To get the best results when reamping, you need a crystal-clear recording of the instrument. The best way to do this is to use an active direct box such as the Radial J48™. Rather than plugging directly into your interface, using an active DI has many benefits.
Can a DI box be used in reverse?
A passive DI can be used backwards. However you need to be aware of the signal levels. What you will now be using as the input is designed to handle mic level signals, and the DI will be giving you a large signal boost.
Can you use a DI box backwards?
What is a Reamp box used for?
A proper re-amping device converts a balanced signal to an unbalanced signal, reduces a high studio-level (line-level) signal down to a low guitar-level signal, and shifts the output to a high instrument-level impedance (typically a guitar pickup impedance).
Can you use a DI box in reverse?
A passive DI can be used backwards. However you need to be aware of the signal levels. What you will now be using as the input is designed to handle mic level signals, and the DI will be giving you a large signal boost. Both of these facts make it easy to overdrive the DI or the device that the DI is feeding.
How do you Reamp a signal?
Reamping is a two stage process whereby you first record a dry or clean track and then re-record the track afterwards by sending the clean tract back through your amps and effects.
What do I need for a Reamp box?
However if you’re planning on recording your amp and reamping later then you’ll need to have a couple of pieces of equipment, the most important of those being a D.I box, reamp box and of course an audio interface. The signal chain should look like this:
Why do I need a reverse Reamp box?
So if your line-level signal for reamping is a standard +4dBu, it will leave the reverse DI at a whopping +25.5dBu! This will clip most guitar pedal and amp inputs. So, while the reverse DI trick does provide ground isolation, the high ratio of the transformer makes it less than ideal for level and impedance matching.
How is a passive DI used in a Reamp box?
A passive DI is a step-down transformer (usually 12:1) that steps an instrument’s volume and impedance down to microphone level. Using it in reverse flips the transformer’s ratio, so the DI will step up your signal by 12x. So if your line-level signal for reamping is a standard +4dBu, it will leave the reverse DI at a whopping +25.5dBu!
Can a Reamp be used as a mic?
Reamping leaves things open for change. Now that you have captured the performance with a clean track, you can send the guitarist to the beach. You are ready to roll up your sleeves and get to work. Send the track-1 clean output to the Radial X-Amp. From there, you can split the signal off to two amplifiers and mic each one independently.
https://www.youtube.com/watch?v=b1O_5gaX4-s
