Why is my blower fan not working?
Why is my blower fan not working?
If you see or hear the fan turn on, your blower motor is not the culprit. If the fan does not start, you have a wiring issue (circuit breaker trips) or motor problem (circuit breaker does not trip). While your thermostat may be at fault, only an HVAC technician can diagnose and remedy the issue correctly.
Why is my AC outside unit fan not turning on?
If the compressor is working, but the fan won’t turn, then the problem is most likely with the motor and/or capacitor. If you don’t hear any sounds to indicate that the compressor is working, and the fan isn’t spinning, the most common causes are a lack of power or a faulty compressor contactor.
Is the front blower on my Tahoe Z71 not working?
Stockton, Ca. Greetings, I have a 2004 Tahoe Z71 with a non working front blower motor. My son, which drives the vehicle, stated that the blower motor just stopped working while going down the road. I began checking it out by checking all fuses and relays.
Why does my Chevy Silverado blower motor not run?
If the blower motor runs when all of the terminals were jumped together, it means the circuit between the resistor connector and blower motor is fine as well as the blower’s motor relay, but the blower resistor is bad and needs to be replaced.
What causes a blower fan to not work?
When this happens, you may notice that you will not feel anything blowing out of the vents at all. This may also cause the blower motor to work intermittently. A blower fan is connected to the negative battery terminal (also called ground) on one end and to the positive battery terminal through a blower motor resistor on the other end.
Why is the blower motor not working on my GMC Yukon?
All appear fine. I then pulled the blower motor out of dash and determined there was power to the plug at the motor. I bench tested the blower and it worked fine. I have power from the switch to the blower resistor and from the resistor to the motor. Plugging the resistor back in, plugging the motor into the resistor but the motor fails to work.