Popular articles

How do I log into my Cisco modem?

How do I log into my Cisco modem?

Your Default Cisco Router Login

1. Connect your device, either computer or mobile, to your internet.
2. Open a web browser and enter the IP address of your router. The IP address used for most Cisco routers is 192.168.
3. From the log-in page, enter your username and password.
4. Hit the Ok button to access your web interface.

How do I log into Cisco EPC3925?

Cisco EPC3925 To Login into the Cisco EPC 3925 modem,click on the following link http://192.168.0.1 or enter this link into a web browser. This will bring you to the Cisco EPC3925 login page. By default modem login is admin and password is admin click the login button to log into your modem.

How can I login to my modem?

First try connecting your computer to the modem using a network cable. Open your Internet browser e.g. Internet Explorer, Firefox, Chrome, Safari, etc. and enter the IP address of your D-Link modem in the address bar: http://192.168.1.1. This should open the login page for your modem’s configuration pages.

How do I connect my Cisco cable modem?

How To Connect A Cisco Router To A Cable Modem?

1. Take a coaxial cable and connect its one end to a wall outlet.
2. Make sure to connect the cable modem’s power cord to an electrical outlet.
3. The cable modem will power up automatically.
4. This will turn the cable modem on.

How can I see who is connected to my wifi Cisco?

Explore this article

1. Cisco and Linksys.
2. Log.
3. Click the Status tab at the top of the screen.
4. Click the button.
5. Check the list.
6. D-Link.
7. Entering the IP address of the router in your browser s URL bar.
8. Click Setup.

How do I connect a console port to a Cisco switch?

Step 1 Locate the console port on the back of the Router/Switch. Step 2 Connect the console (or rollover) cable to the console port on the Router/Switch. Step 3 Use the correct adapter to connect the other end of the cable to your terminal or PC.

Which type of cable is used to connect to a Cisco console port?

RJ-45 connector
The console port uses an 8-pin RJ-45 connector. If you did not order a console cable, you need to provide an RJ-45-to-DB-9 adapter cable to connect the switch console port to a PC console port.

How to configure Cisco ubr9xx cable modem?

Complete these steps to configure the uBR9xx as a router: Remove the default commands bridge-group 59 and bridge-group 59 spanning-disabled from the Ethernet 0 (e0) and cable-modem 0 interfaces of the cable modem. Issue the command no cable-modem compliant-bridge on the uBR9xx under the cable 0 interface.

How do I create a cable modem scope?

Create scopes to associate with the Cable Modems and Cable Modem Clients policies. To make a new scope, click on [email protected] in the main menu, and then click the Add tab. This will allow you to add a new scope. Enter the name of the new scope and then select the appropriate policy.

What are the Cisco IOS commands for cable modems?

The Cisco IOS commands cable-modem boot admin 2 and cable-modem boot oper 5 were added under the cable interface for cable modems to support a DOCSIS Engineering Change Notice regarding recovering from failed software upgrades. Those commands should not be changed or removed under any circumstances.