How do I overclock my MSI GTX 970?
How do I overclock my MSI GTX 970?
Overclocking: By increasing the frequency of the videocard’s memory and GPU, we can make the videocard increase its calculation clock cycles per second….With AfterBurner we applied:
- Temp Target 80 Degrees C.
- GPU clock +185 MHz.
- Power limiter 110%
- Mem clock +500 MHz.
- Volatge + 87Mv.
- FAN RPM 70% (remains silent)
What is a good overclock for GTX 970?
The GTX 970 is clocked at 1,050MHz, and presumably could hit 1,175MHz with GPU Boost. And here, with this stable overclock, the card gains at least 335MHz to that peak. That’s unbelievable.
Is GTX 970 80c safe?
80C is still well within safe temps (max 98C). You could also change the fan profile and set it to a more aggressive fan curve to help keep temps down with a program like MSI Afterburner. Another thing that will help, at least a few degrees C, is replacing the thermal paste on the GPU.
Is it safe to overclock a GTX 970?
There is no safe overclock, you always take a risk when doing an overclock. You can run a GTX 970 at 1.325ish volts and 1.7ghz core clock (depending on silicon), if you’re lucky you can run it as long as until you switch the card, it could also just die in 5minutes, it’s really.
What should the temp be on a MSI GTX 970?
(I use MSi Afterburner 4.1.0) Core Voltage +45 Power Limit +110 Core Clock (MHz) +185 Memory Clock (MHz) +500 temps max out at around 77C but I have cards above and below the 970’s so the air flow isnt the greatest. Alright, thanks for sharing these.
Can a GTX 970 run at 1.325 volts?
You can run a GTX 970 at 1.325ish volts and 1.7ghz core clock (depending on silicon), if you’re lucky you can run it as long as until you switch the card, it could also just die in 5minutes, it’s really. The general thumbrule is the higher you overclock the more you degrade your hardware. 0
What happens when you overclock a graphics card?
More advanced users push the frequency often way higher. Usually when your 3D graphics start to show artifacts such as white dots (“snow”), you should back down 25 MHz and leave it at that. Usually when you are overclocking too hard, it’ll start to show artifacts, empty polygons or it will even freeze.