What does a blinking snowflake mean on a White-Rodgers thermostat?
What does a blinking snowflake mean on a White-Rodgers thermostat?
If the “cool on” or the snowflake icon is flashing, the thermostat is in delay mode, which can take up to 5 minutes. This delay is to protect your equipment from short cycling. 3.
What does the flame icon mean on a White-Rodgers thermostat?
The Flame icon ( ) will display flashing to indicate that the Aux system is operating. 3. Press to adjust the thermostat below room temperature. The Aux heating system should stop operating.
How do I get my White-Rodgers thermostat out of lockout mode?
To unlock the thermostat, press and SYSTEM buttons at the same time until LOCK is no longer displayed.
Why is my White Rodgers thermostat not working?
Your White-Rodgers thermostat may be faulty for a number of reasons. The problem may be as simple as needing to replace the batteries. However, your home’s power supply may have blown a fuse or have a tripped breakers, especially if your heating and cooling systems run continuously.
How do you program a White Rodgers thermostat?
Programming Digital Thermostats
- Press the “Set Time” button.
- Now, use the Up and Down arrows to select the proper hour.
- Press “Set Time” again to select the hour and move onto setting the minutes.
- Use the arrow keys again to select the correct minute.
- Press “Run program” to confirm the time setup.
Why is my White-Rodgers thermostat not working?
Do you have to reset thermostat after changing batteries?
3. Non-Programmable Digital Thermostat. Resetting a non-programmable digital thermostat simply requires taking the face off and pressing the reset button for five seconds or removing the batteries for five seconds. After doing one or both of those options, your thermostat should reset.
Why does my thermostat show a flame?
The flame icon on your the thermostat flashes when the compressor is locked. This can occur as a result of power loss or interruption. In other words, if the flame icon on your thermostat is blinking, your compressor is likely cut and you will need to reset your thermostat to reactivate it.
How do you test a White-Rodgers thermostat?
Open the thermostat cover and remove the wires from terminals R and C, and take out the batteries for two minutes. Replace them. Lower the thermostat’s temperature below the ambient temperature again and listen for a click again. If you don’t hear a click, replace the thermostat.